Proper use of cross roller guide rail shared by High Precision Motorized Goniometer Stages sipplier.
Padwell company has been dedicated to the cross roller guide, cross guide,
cross needle guide, slide table cylinder guide, slide table and non-standard
customized completely restore the drawing effect, meet the needs of customers
and other products manufacturing research and development.
The correct way of cross roller guide is as follows:
1. Wipe the anti-rust oil on the base level of the part with oil remover.
Because the base level of anti-rust oil is easy to rust, therefore, can be used
on low viscosity paint, re-use.
2. After the side base plane of part 1 ~ 3 is positioned on the side base
plane of step positioning, prefix it on the base plane of bed and slide table
with screws. The tightening force should not be too large, so that the bottom
surface of part can be tightly connected with the relative base plane. Press the
parts with pressing plate, cross roller guide rail, so that the side of the
parts and installation datum plane. Use torque wrench to tighten the mounting
screws of parts one by one according to the torques specified in the table
below, starting from the middle and tightening them to both ends in cross
order.
3. Temporarily fix the parts on the adjustment side.
4. Insert the cage carefully near the center.
5. Install the end block on the end of the guide rail.
6. Move the slider left and right to the end and adjust the cage to the
center of the bed.
7. Hit the watch head on the center and side of the slide.
8. Move the slide table to the end of one side, cross roller guide rail
manufacturer, and confirm that there are rollers at the right place of
adjustment bolts, gently tighten the adjustment screw.
9. Move the slide table to the end of the other side and tighten gently as
above.
10. Move the slide table to the central position and tighten the adjusting
screw gently.
11. Repeat steps 8-10 to cross roller guide type and adjust the clearance of
slide table to 0.
12. Follow steps 8-10 to tighten the adjustment screw by referring to the
torque values given in the following table.
13. Finally tighten the part 4. Similar to the tightening step of the
adjustment screw, move the slide table to ensure that the tightening place of
the bolt is facing the roller.
In order to ensure the quality of cross guide rail, each manufacturer must
use qualified raw materials. Qualified raw materials are the quality of finished
products produced. Only when good raw materials are taken can good products be
produced. Therefore, production enterprises must pay special attention to the
quality of raw materials when selecting materials.
In the production, we must use accurate measuring instruments, so as to
ensure the accuracy of the products produced, when we use the products will not
cause unnecessary losses to us due to inaccuracy.
That's all for the sharing, thanks for your reading, and we also supply High Precision Motorized XY Stages for sale, if you have any demand for our products, just feel free to contact us.
